THEY RUINED MY SIDING BATTERIES ARE FALLING OF THE WALL ELECTRICAL IS SHAMEFUL THE SYSTEM COST 93K THEY ARE THE WORST AFTER SALES SERVICE COMPANY EVER CALL THE MANUFACTERER OF eg4 THEY WILL CONFIRM MY STATEMENTS THEY ARE ONLY IN IT FOR THE MONEY AND GIVE A SHIT LESS AFTER THE HALF ASS INSTALL IF YOU ARE HAPPY. sIDING COST $34,000. ITS FULL OF HOLES AND HAS PVC GLUE ON IT .
Wire is a shit show it is a service companies worst nightmare this should have benn trimmed.
Units mounted outside of kitchen window held to house with screws and fender washers that drilled through siding and left holes for rain to get into new siding these weigh around 300 lbs
battery cables rubbing against housing and not servicable the black plate is just laying in box not installed
CT devices not installed just left in panel in box. Screws are missing in next picture and if you look all pics have screws laying around or missing
THESE CT CLAMPS ARE LAYING ACROSSED WIRE TERMINALS INSIDE OF FLEX BOX THAT COST AROUND 4K THAT CONTAIN THE INVERTER WHICH IS NO DAMAGED. THAN GOODNESS FOR THE MANUFACTERER THEY ARE SENDING A NEW ONE OUT EG4 IS THE COMPANY AND THEY HAVE GREAT SUPPORT AFTER THE SALE
THE EMPTY CONDUIT ON THE RIGHT MUST NOT HAVE BEEN NEEDED AND IF IT WAS NOT THERE THEN GLUE FROM PVC ON THE SIDING ALSO WOULD NOT BE THERE
THE WIRES IN MIDDLE TOP PREVENT COVER PANEL FROM BEING INSTALLED MAYBE THATS WHY IT FELL ON THE GROUND WHEN IT WAS OPENED
Battery is falling of the wall it might be becuase screws are missing but I estemate at least 100 screws are not in place and the conduit is mounted in front of them so if they did screw it on the panel would not be accesible so maybe thats why they did not do it.
They send young inmature boys to do install I have panels with red paint on them they hauled them from house to field I had to goe out and move them after the first load. or should i just say baby sitting them.
switch for comms in bottom of cabinet not mounted and orange and gray ethernet is pulling out of board because it is not long enough. This is the unit that has already failed.
Dont exspect them to backfill the trench
JFC
Yes, solar panels are easily damaged by walking on them.
While the top layer of tempered glass is designed to handle environmental stress like hail, human weight causes the glass to flex inward. This pressure leads to several hidden and permanent issues:
Micro-cracks: The brittle silicon photovoltaic cells beneath the glass (often as thin as a potato chip) are forced to bend and snap. This creates microscopic fractures that ruin energy output over time.
Delamination: The pressure can cause the structural layers of the panel to separate, breaking internal electrical connections.
Hotspots & Fire Hazards: Damaged cells interrupt electricity flow, creating internal hotspots that can be a major fire risk.
Warranty Void: Stepping on panels typically violates the manufacturer’s warranty.
Because the damage is often internal, the glass may look perfectly fine while the panel secretly underperforms or fails prematurely.
This is the kids playing during a 93k job how would you feel if you wrote that check.
here is a breif text and ameren did not approve instal on first round . Be ready to clean the garbage up they don't
Yes I keep bitching about siding but I was proud of it and the google review shows that siding sofit facia insulated-siding and gutters. $34,000
google review for siding. maps.app.goo.gl/D6xCNXw2jjdhNtey9